2005 Chevy Colorado Driver Window And Door Locks Not Working

I ve run out of things to try other than going to a chev shop to get my driver s window and all door locks to work.

2005 chevy colorado driver window and door locks not working.

That s to enable the bcm to trigger locking and unlocking. I checked all fuses even 68 relay but still could not find problem i drove 18 miles in 30 degree weather at nite got home and was very confused with this truck. You have the fuse the switch and relay module in the door window motors and the wiring between them. For the locks the bcm does have two signal outputs to the window door lock module.

Can every admit that chevy is really on the ball these days. For the windows the bcm is not involved at all. I got the driver window and door locks not working again. I found this forum while searching for a solution to a recent problem.

I was getting frustrated since i really do not have the money to replace parts. The driver side window was stuck down and all door locks would not work all the other windows went up and down as they should but still no drivers window or door locks. With the driver s window partial down and plastic taped over it i haven t driven around very much other than one drive 22 miles down the highway and back. After i charged it up the driver s side front door power window and door locks are not working.

I disconnected the negative battery terminal for cleaning and when i reconnected it i found that my driver s side power window but not the passenger side and both power door locks did not work. I have a 2004 colorado 4x4 ext cab 5cyl z71. I have checked the fuses u read more. I found other solutions that were said to work and did not work.

On my 2005 chevy colorado my battery died while my truck sat for two weeks. For that reason lets focus there for the moment. My 2005 z71 ls colorado was missing 20 amp fuse for pwr lcks put one in and locks started working and driver window would go down but not up took the driver door control apart and used a paper clip to short the connections on the circuit board found that the white pegs that make the connection from the buttons to the circuit board were out of place i needed to keep shorting the board and.